Technical points on bottle tremella

The bottle production Tremella production cycle is short, not subject to seasonal restrictions, less labor, income is fast, is a good family sideline, bottle Tremella method is:
First, the preparation of culture materials
1. The formulation of culture materials: wood chips 50 kg, bran or rice bran 15 kg, plaster 1 kg, sucrose 0.75 kg, soybean powder 1 kg, magnesium sulfate 0.25 kg, water 60-70 kg.
2. Preparation method: Mix wood chips, wheat bran, gypsum and soybean powder proportionately, then pour the warm water-soluble sucrose and magnesium sulfate, and mix thoroughly. Hand a handful of mixture to give water between the fingers but not drip.
3. Bottling and disinfecting: Mix the well-mixed material into a 500-750-gram wide-mouth bottle, fill it with compaction, and press an inoculation hole with a size of bean, a depth of about 2 cm, and a width of 1.5 cm in the middle, and then Cover the bottle mouth with plastic film plus a layer of kraft paper, and fasten it with a wire, place it in a pressure cooker, keep it at 100°C, and sterilize it continuously for 7 hours. After cooling, move it into the inoculation room for use.
2. Inoculation Put the sterilized cultivation bottle and the tube containing the bacteria strain into the inoculation box and inoculate it. Re-attach the film and paper and fasten it. Each strain of 750 g of bacteria can inoculate 50-80 bottles of cultivation bottles.
3. After culturing and inoculating, the cultivating bottles are immediately moved into the culturing chamber, and are layered and discharged on a wooden shelf, each with 5-6 layers. Each layer is separated by about 40 centimeters. After being put on shelves, the upper and lower layers are replaced once every 3-4 days. Prevent temperatures from varying.
IV. After harvesting and inoculation, after 30-40 days of cultivation, the diameter of the white fungus is 10-16 cm, and when it is white and transparent, it can be harvested. Use a knife to cut off the entire crop at the base and immediately dry it to prevent mildew.

Fluorine-Containing Methylbenzene products can be used as herbicides in the manufacture controlling wheat fields, cotton fields and other broadleaf weeds and perennial weeds. It can also be used in the manufacture of antipsychotics drugs.
The Fluorine-Containing Methylbenzene products must be kept under seal, once exposed to light will immediately cause discoloration. It should also be stored in a cool, ventilated warehouse, away from fire and heat. Compartment temperature should not exceed 30 ℃. And make the appropriate technical measures for fire and explosion. Products will Decomposition by high fever and emit toxic gases, such as carbon monoxide, carbon dioxide, hydrogen fluorid. Due to ts vapor is heavier than air, it can spread from low place to far away places. In case of fire conditions, should not fire with water. In case of a small amount of leakage should be evenly sprayed with dilute hydrochloric acid. In case of large spills should build a causeway or trenching asylum. The transfer pump to tankers or exclusive collector, recycling or shipped to the waste disposal sites.

Fluorine-Containing Methylbenzene

Containing Methylbenzene, 5-Fluoro-3-Nitrotoluene,2-Bromo-5-Fluorobenzotrifluoride

Taizhou Volsen Chemical Co., Ltd. , http://www.volsenchem.com