Beauty equipment maintenance method

How to properly use beauty instruments and extend their service life is especially important. Most of the beauty equipments produced by the regular manufacturers are of good quality. If they are not handled properly by humans, problems usually do not arise. Of course, in addition to the quality clearance of the manufacturers, the normal users must also do some routine maintenance. First, the instrument must not be placed in a place exposed to moisture, direct sunlight, or inflammable or explosive materials to prevent accidental accidents. Followed by cleaning, the surface of the instrument should be kept clean. It is best to cover it with velvet or gauze when not in use to prevent dust. For those instrument accessories such as probes, patches, shovel heads, electrode packages, etc., one person must do one cleaning at a time. When cleaning, wipe it with a dry rag or a wrung wet rag. Do not wash. Third, the matching cosmetics must be used in accordance with the requirements of the instrument manual. For example: probes, shovel heads, patches, etc. must not be in contact with oily or corrosive cosmetics. Finally, all wire-type fittings are strictly prohibited from being pulled and twisted to prevent the power cord from breaking and all instruments are not allowed to enter the water. What are the requirements for the specific operating personnel? Many instrument panels are now using soft keys, which are brittle. If the operator's nails are too long or they are indiscriminately pressed, it will cause cracks; some instruments and accessories contact the interface with the upper and lower points, operators often ignore this, and believe that To plug in, it will also damage the contact; In addition, some operators forget to turn off the power after the operation, causing the instrument to dry, leading directly to shorten the life of the instrument. Because of the different effects of beauty equipment, the value is also very different, then what are the differences between ordinary instruments and high-end equipment in maintenance? The materials used in high-end equipment are precise, and the requirements for the power supplies and other things that are matched with them are strict. Therefore, they must be strictly in accordance with the requirements in the manual. In addition, high-end equipment requires high requirements for operators, so they must undergo professional training before they can operate on the machine. We often find ourselves at a loss when there is a problem with the instrument. However, there are some problems that we can handle on our own. The common problems are the following: The first kind is that the normal parts of the instrument have no output. The reason is that the conductive wire of the accessories is damaged and the customer's skin is too dry. Not conductive or contact with the customer's skin is not good, the treatment method is to replace the conductive line, at any time with the customer's skin smear with the instrument's products, and maintain the skin's wet state; the second, the instrument is normal but the button fails, because the button Aging caused poor contact, only the host sent back to the original factory maintenance; the third, the instrument is not displayed, because the power plug is not connected or the power switch is not open, just check the power cord, turn on the power switch on it; fourth There are acupuncture sensations in the contact positions of the parts and accessories. The reason is that there is damage to the skin of the accessories, there is oil, or the function of the accessories is deteriorated. The countermeasure is to avoid the damaged skin position, clean the skin, and replace the accessories.