There are many factors that cause a trip, and if it is not repaired in time, it will have serious consequences. First, the bearing wears. After the bearing wears heavily, the associated shaft ends are deflected, causing the gears to be loosely engaged and not engaged. At the same time, the teeth form a slope causing a shift. Bearing wear and gear wear should be checked and replaced if necessary. The gear oil is then released for warming treatment. When the temperature is warmed, iron scraps and impurities in the gear oil are precipitated, and if necessary, the gear oil is replaced. Second, gear teeth appeared one-sided. As the gear oil in the gear box is too small, the gears can not be effectively lubricated and dissipated, resulting in a reduction in the hardness of the teeth, which results in accelerated wear of the gears and the phenomenon of “sweeping and sweeping†of the gears. For a long time, the gears could not be meshed or even meshed, and they would be disengaged after meshing. Check gear oil level, add gear oil, but can't add too much. Adding too much can cause bad symptoms, such as poor heat dissipation, too loud noise, oil leakage, large rotation resistance. Third, improper adjustment of the shift lever. The meshing position of the gear is predetermined, and due to improper adjustment of the shift lever, the gear mesh will shift. If you work for a long time, the side of the teeth will be tapered and cause a shift. Open the transmission cover and move the fork to the optimal state for engagement. Then adjust the shift lever and lock it. Check if the gear is over taper and replace it if necessary. Fourth, the limiting ball pressure in the fork is too small. Usually there is a pressure spring on the fork limit ball, which is used to adjust the pressure of the ball. If the pressure is too large, it will cause difficulty in catching and picking up. Limit slot on the speed shaft, if the limit slot and the ball wear will cause a shift and chaos. Repair or replace depending on the degree of wear. There are many reasons for a trip. If there is a trip, the cause should be identified and repaired. Hardware Locks,Stainless Steel Plane Locks,Flat Locks,Plane Locks Ningbo Hengchieh Locking Technology Co., Ltd. , https://www.hengchieh.com